Tag Archives: Saltless Water Conditioner

How To Clean a Catalytic Water Conditioner Core

This is good information to know when it comes to come maintenance on a water conditioner.  Watch the whole “how to” video below.

We’re going to show you now, how to clean the core in one of our exterior catalytic water conditioners.  (Water conditioners help solve hard water issues without the use of salt like a regular water softener would use.)

First, you need to break the seal on the unions so that you can remove the core. This will require a pipe wrench and a pair of Channel locks

It is best to disconnect the unit at both ends with both unions, so you can easily slide the core out for cleaning.

The core will slide out of the body with the serial number end at the top. . .

The second step in this process is to clean the catalytic water conditioning core. This is best done with a mixture of muriatic acid to water. So, we fill our bucket up with about four gallons of water, and we add one half a gallon of muriatic acid to the water to clean our core. Obviously, be very careful in handling muriatic acid. Be sure to wear eye protection and follow all the instructions on the bottle.

Water Conditioner Core Maintenance

Next, we are going to dip our catalytic conditioning core into the muriatic acid and water solution. Again, pay attention to the warning labels on the muriatic acid and follow all the instructions. With the core in the murky water and the muriatic acid mixture, we found that it’s best to leave it in for 10 to 15 minutes for a proper cleaning.

As you can see it.

After soaking in the muriatic acid and water for about five minutes, you’ll notice the core returns to its natural color of grey. Be sure to thoroughly rinse your core with clean water prior to re-insertion.

This core is now clean and ready to be re-assembled into the conditioner.

Also, be sure to dispose of your muriatic acid and water solution properly with regard to codes in your own area.

Before reassembling the catalytic conditioner into the copper body, be sure to use Teflon tape amply on the threads for a complete seal.

Make sure when you put your Teflon tape in place, that you cover the entire lip to create a proper seal and for ease of re-installation.

Take note that the serialized end is the inlet. Refer to the sticker on the body for the proper flow direction.

Once the conditioner is back in the place, the tank can be reconnected to the system and bought online.